Garage Storage Cabinets by GSC - Distributors Wanted! DIY or Professional Installation

Thank you for purchasing Garage Storage Cabinets! Read through the instructions before beginning the installation process. Contact your local GSC™ dealer if you have questions about your installation. We hope you enjoy your new GSC™ Cabinet system.

Download these instructions to print or read offline



			Assemble the hinges: Put the hinge and plate together as shown.
			45 degree Hinge is used on corner cabinets only.
			Tighten the back screw.
			Place hinge into the pre-drilled cup hole in the door.
			Tap into place using a rubber mallet.
			Line up the Hinge Plate with the pre-drilled holes in the Side Panels. This will place the door in the proper position.
			Screw in Euro Screws provided. Adjust hinges by using the front and rear screws. Tightening the front screw narrows the gap. Loosening the front screw widens the gap. Align the gap between the doors to 1/8". The rear screw is loosened to allow the door to move in or out and then retightened to hold the adjustment.
			Each hand has two screws provided.
			Place the Handle Jig (if supplied, or makr your own) from the top of the cabinet on all 6' cabinets. (This can be adjusted according to the customer preference.) Drill screw holes through jig holes. Upper Cabinets: Line the bottom of the jig up with the bottom of the cabinet door. Drill screw holes through jig holes. Workbench Cabinets: Line the top of the Handle Jig up with the top of the cabinet door. Drill screw holes through jig holes.		The handle jig can be used for the melamine cabinets as well as the standard unfinished cabinets. Place the alignment guide on the handle jig on the edge of the door. Measure down to the right height. Drill the pair of holes next to the handle only. (Drill each door separately).
			Mount handles using screws provided.
			Apply Bumpers ot the shelf 1/2" away from the adjacent door.
			Set the Top Cap Shelves in place and align with the front and side of the cabinet. Use brads to secure to the sides.



	Stud Finder 5/16” Hex Bit Standard Screw Bit Set Standard Drill Bit Set Chalk Line Brad Gun 1-3/16” Brads 4’ Level 14V Cordless Drill or Equivalent Small Portable Air Compressor 2” Rubber Mallet Wood Glue Phillips Screw Driver Jig Saw Additional Hand Tools Sharpie Pen